Custom Built Clubs

How we build your Custom Golf Club

1. We have the customer hit balls and we check swing speed, tempo, ability and any physical problems.

2. From this we determine shaft flex, length, shaft material (steel or graphite), lie angle and grip size.

3. Club heads are weighed to ensure the consistent graduation in grams between heads. This applies whether we are using new components or rebuilding pro line equipment.

4. Shafts are deflection matched on a Flexmaster to ensure that every shaft in the set is exactly the same strength. This is accomplished by butt trimming each shaft to the desired strength. At the same time each shaft has the spine aligned.

5. The shafts are butt cut to strength, the head is dry fitted, the playing length measured and the appropriate amount is trimmed from the tip of the shaft.

6. Tip of shaft is abraded to ensure a proper bonding of the epoxy.

7. The ferrule is installed, the head is epoxied to the shaft with the spine in proper alignment.
8. After the epoxy has cured, the clubs are checked for swing weight and any adjustment made using small quantities of tungsten powder poured down the shaft and secured with a small cork.

9. Clubs are gripped with the proper size grip.

10. Each club is checked in a frequency analyzer and a charted profile is created.

11. Clubs are cleaned, ferrules are turned down and polished & shaft bands are applied.

13. Lie and lofts are checked and adjusted as necessary.

14. All metal wood clubs receive a head cover.

9586 Windsor St. Chilliwack, B.C. Canada V2P 6C2 E-MAIL US

GOLFIX INTERNATIONAL CLUBMAKERS EXCHANGE IAN B. McARA CLASS "A" CLUBMAKER

PHONE: 604-792-6198 FAX: 604-792-8474 TOLL FREE 1-800-661-9881

BACK TO THE MALL